Canon imagePROGRAF W6200, Service Manual, Page: 256 / 311

J209
Pin number Signal name IN/OUT Function
1 GND –– GND
2 DSOUT2_A OUT LICC2 analog output
3 DSOUT1_A OUT LICC2 analog output
4 LICC2_LD IN LICC2 input data latch signal
5 LICC2_DT IN LICC2 input data
6 ADTRG IN LICC2 output sample hold
7 LICC2_CLK IN LICC2 input data clock
8 GND –– GND
9 CRENCA OUT Linear scale phase signal A
10 CRENCB OUT Linear scale phase signal B
11 HEADEEPCS IN Head EEPROM chip select signal
12 HEADEEPWD IN Head EEPROM write signal
13 HEADEEPRD OUT Head EEPROM read signal
14 HEADEEPCLK IN Head EEPROM data transfer clock
15 GND –– GND
16 HDCVR OUT Carriage cover opening/closing sensor output
17 CMOUT OUT Head overcurrent detection signal
18 PLED IN LED voltage control signal for media sensor
19 PSNS OUT Media with sensor output
20 DCDC_OVP OUT Head overvoltage detection
21 –– –– ––
22 GND –– GND
23 –– –– ––
24 H5VENB IN Head logic voltage on/off control signal
25 VHENB IN Head drive voltage on/off control signal
26 +3.3V IN Power supply (+3.3V)
27 OUTENBB IN IC212 output enables signal
28 +5V IN Power supply (+5.1V)
29 +5V IN Power supply (+5.1V)
30 GND –– GND
31 VM IN Power supply (+24V)
32 VM IN Power supply (+24V)
33 VM IN Power supply (+24V)
34 VM IN Power supply (+24V)
35 VM IN Power supply (+24V)
36 MGND –– GND
37 MGND –– GND
38 MGND –– GND
39 MGND –– GND
40 MGND –– GND
Part 5: Maintenance W6200
5-88