Canon imagePROGRAF W6200, Service Manual, Page: 201 / 311

5.2.11 Boards
Do not replace the system controller and engine controller at the same time.
Each controller has important stored information such as the setting values and
carriage driving time. To retain this information, before a controller is replaced, the
information in the controller is temporarily stored in the other controller using
internal communication. After the replacement, the information is automatically
written into the new controller. Therefore, the two controllers cannot be replaced at
the same time.
Also, when the system controller and engine controller are replaced as service parts,
check that the firmware version is the latest available. If it is not, update the firmware
to the latest version.
If ERROR S04011 appears, it indicates that the voltage of the lithium battery in the
system controller is low and the battery must be replaced.
a) Replacing the system controller
When replacing the system controller original information of the following
items in the MAIN MENU and the SERVICE MODE are not backed up and
not restored in the new system controller.
Save the original information accordingly, prior to the replacement of the
system controller in case of need.
• MAIN MENU>Interface Setup>IP Setting
• SERVICE MODE>DISPLAY>WARNING
• SERVICE MODE>DISPLAY>ERROR
• SERVICE MODE>DISPLAY>P-SETTING
• SERVICE MODE>COUNTER>MEDIA-00 to MEDIA-OTHER
1) Turn off the power, and replace the system controller.
2) Turn on the power while holding down the
[Cancel] button , [Enter] button , and
[Online] button .
(The printer is started in Board Replace mode.)
3) Check that "Canon W6200PG" appears on the display, and then release the
buttons.
(The message lamp turns on when the printer enters Board Replace mode.)
4) Wait until "REPLACE MODE" appears on the display.
5) Select "S/C REPLACE", and then press the
[Enter] button .
6) Set the current year (last two digits) with the [<] or [>] button and press the [ ] or
[Enter] button .
7) Set the current month with the [<] or [>] button and press the [ ] or [Enter]
button .
8) Set the current date with the [<] or [>] button and press the [ ] or [Enter] button .
9) Set the current hour (0 to 24) with the [<] or [>] button and press the [ ] or [Enter]
button .
10) Set the current minute with the [<] or [>] button and press the [ ] or [Enter]
button .
11) Press the [Online] or [ ] button .
12) Check that "Turn Power Off!!" appears on the display, and then turn off the
power.
13) Turn on the power.
14) Check the firmware version. If it is not the latest version, update the firmware to
the latest version.
15) In the Main menu, select Interface Setup --> IP Setting, and then make the
settings again.
5-33
W6200
Part 5: Maintenance
CAUTION
>
>
>
>
>
>