![background image](http://html1.mh-extra.com/html/campbell/crvw3/crvw3_instruction-manual_489101097.webp)
CRVW3 3-Channel Vibrating-Wire Datalogger
84
Choose one of your deployed CRVW3 devices that has a single-hop
connection to the base station. Click on the
CRVWSeries
item in the network
map and press the
Rename
button. Rename the device with the name of that
station which you designated in your radio network planning documents (see
(p. 62)
).
In the
Hardware
tab, set the
PakBus Address
value to match up with the
value that was configured into the CRVW3 device with
DevConfig
or with the
Network Planner
. Press
Apply
.
If you are using PakBus encryption, the proper key should be
entered in this screen. This key should match the value that was
previously set in the CRVW3 using the
PakBus
tab in the
Settings
Editor
tab of
DevConfig
. Refer to the online help system of
DevConfig
,
PakBus Encryption Key
field topic for more
information. Also, if a Security Level 1, Security Level 2, or
Security Level 3 code was set for the CRVW3 in
DevConfig’s
PakBus
tab, put the proper code in the
Security Code
box of this
screen. For more information about security codes, refer to your
datalogger manual or the
DevConfig
help.
Now switch to the
Clock
tab. The
Check Clocks
and
Set Station Clock
buttons should be active. If they are not, press the
Apply
button.
NOTE
Summary of Contents for CRVW3
