/output [pw=password]
m
=
v
…
Controls the relay outputs, where:
r
is “r”, “rly”, or “relay”;
n
is “1” or “2”;
v
is “0”, “o”, or “open” to open; “1”, “c”, “close”, or “closed” to close.
r
and
v
can be in any case, upper or lower. Both relays can be set from one command.
SMS Commands
•
SMS Commands
– Enable allows the Vanguard 3000 to respond to received SMS commands.
– Disable causes SMS messages (that start with a slash) to be accepted but quietly discarded.
•
Password
In nonblank, all commands require the password in the form pw=password as one of the arguments. The pw prefix
can occur in any case (“pw=”, “PW=”, “Pw=”, etc.) but the password must be in the exact case as entered on the
web page.
Allowed Senders
•
Sender 1 / Sender 2 / Sender 3
Commands can be restricted to be accepted only if they arrive from one of up to three “friendly” SMS Sender
addresses. Sender addresses are typically numeric digits only including the country code prefix. The check box in
front of each Sender address can be used to enable or disable the address entered in the adjacent field. If all three
addresses are disabled, then commands will be accepted from
ALL
senders.
•
Respond only to Senders
For security, command responses, including error messages, can be restricted to be returned only to the registered
Sender SMS addresses.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 77
