Step 8
Once the “IPsec SA established tunnel mode” message is displayed in the tunnel negotiation log, a
communication test is required to ensure point-to-point connectivity. From the Application Server located behind the
VPN server, ping the LAN IP of the local device connected to the Vanguard 3000 LAN port. The pings should receive
replies from the local device.
Alternatively, ping the Application Server IP Address from a device on the Vanguard’s local LAN and receive replies
similar to the following.
[Prompt]$ping 192.32.8.254
PING 192.32.8.254 (192.32.8.254) from 10.192.10.195
64 bytes from 192.32.8.254: seq=0 ttl=126 time=136.646 ms
64 bytes from 192.32.8.254: seq=1 ttl=126 time=134.848 ms
64 bytes from 192.32.8.254: seq=2 ttl=126 time=135.274 ms
64 bytes from 192.32.8.254: seq=3 ttl=126 time=133.018 ms
^C
--- 192.32.8.254 ping statistics ---
4 packets transmitted, 4 packets received, 0% packet loss
round-trip min/avg/max = 133.018/134.946/136.646
Repeat the above steps to configure and enable the second tunnel.
To delete a tunnel or change configuration settings, the tunnel must first be disabled: uncheck the Ena check box
associated with the tunnel in the Tunnel Table.
•
To change settings, enter the Tunnel Item number in the Tunnel Configuration section, enter the configuration
settings, and click
Add/Update
.
•
To delete a tunnel, click the
Del
link in the far-right column that is associated with the tunnel item.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 95