•
UDP Host (1,2,3) Format
Reports in the specified format (see the table above) are sent to the specified IP address & port.
NOTE:
Different reports can be directed to the same UDP Host address and port.
•
UDP Host (1,2,3) Address
IP address of the UDP Host in dotted decimal format.
•
UDP Host (1,2,3) Port
IP Port of the UDP Host (1024-65535).
Store and Forward Settings
The Vanguard 3000 router can be configured to store reports generated by the Remote Delivery configuration when
out of coverage. Those reports will be forwarded to the specified host(s) when the router reestablishes its cellular
connection.
•
Store and Forward
Enable or disable the Store and Forward feature of the Vanguard 3000.
•
Deliver messages every ( ) seconds
This specifies the rate used to deliver the stored messages to the host(s) when the unit is again within coverage.
This MUST be configured faster than the reports being generated by the Remote Delivery configuration.
•
Max reports to store
This specifies the maximum number of reports to store. When filled, the oldest reports will be overwritten by new
reports. (This maximum is divided by the number of different formats that have to be stored and forwarded. For
example, if remote hosts only receive the GGA message, then up to 1800 reports can be stored; if remote hosts are
to receive GGA and RMC messages, then up to only 900 pairs can be stored.)
3.8.2
STATUS
This section displays the current status of the GPS receiver. Click
Refresh
to update the display.
Figure 45 GPS — Status
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 72
