80
Make sure that the charger's power cord is correctly and securely plugged
into the charger's power socket.
Then connect the charger to the power grid. LEDs on the control element
indicate the charging activity, the battery charge state and any error mes-
sages.
The required charging time depends on the residual charge of the battery
and the ambient temperature.
When the battery is fully charged, all LEDs go out and the board computer
shuts down. Then disconnect the charger from the power grid. Finish by
removing the charging plug from your CS. The rechargeable battery will
automatically switch off.
Close the charging port with the cover.
After the drive system is switched on again, your CS is ready to ride again.
For more information on how to charge the battery see the chapter
“Safe
handling of the rechargeable battery“
and the system instructions of the
drive system manufacturer BOSCH.
