Cabletron Systems SmartSTACK ETHERNET ELS10-27, User Manual

Page: 36 / 126

1-20
Introduction
LCM Command Summary
help or ? Display this menu
addresses display [any] [ADDR [MASK]] to display learned addresses
arp display to display the ARP table
baud [BAUD-RATE] to change the console baud rate
bridge [PORT-RANGE [OPTIONS] to set bridging methods
community to change the password/community
disable [? for syntax] to disable a set of ports
enable [? for syntax] to enable a set of ports
erase to erase conÞguration
exit or logout to logout
ident to display unit identiÞcation
igmp [on | off] to enable IPM Þltering by snooping IGMP
ipaddr [IPADDR [MASK]] to set or display IP addresses
ipmÞlter [? for syntax] to statically Þlter out ports
ipmrouter {add | delete} PORT-RANGE to set or display IP Multicast Router ports
kill {session-number} to kill a session (console use only)
mirror [? for syntax] to set or display port mirroring
ping [-rvsx] HOST [DATASIZE [COUNT]] send ICMP ECHO_REQUEST pkts
port [? for syntax] to set or display port parameters
query [on |off] [name] to act as an IGMP Querier
reboot [? for syntax] to reboot the unit after SECONDS
route [? for syntax] to display routing table information
session to display current LCM sessions
switch [? for syntax] to set or display switch parameters
status[PORT-RANGE/clear PORT-RANGE] to display unit or port status
sttimer [TIMER-VALUE] to set or display st age time
traceroute [? for syntax] to print the route taken to a host
trapcontrol [on | off] to set or display traps control value
traplog to display the most recent SNMP traps
trunk [? for syntax] to set display trunking status
vlan [? for syntax] to conÞgure IEEE Vlans
workgroup [? for syntax] to set or display workgroups