Cabletron Systems SmartSTACK ETHERNET ELS10-27, User Manual

Page: 41 / 126

Introduction
1-25
Disable
If the disable command is entered without any port(s) speciÞed, the
display reports the state of all of the ports. It does not disable any of the
ports.
ELS10-27> disable
Usage: disable [PORT-RANGE]
Port 1: Enabled, Rip listening, port w/o link
Port 2: Enabled, Rip listening
Port 3: Enabled
Port 4: Enabled
Port 5: Enabled, port w/o link
Port 6: Enabled, port w/o link
Port 7: Enabled
Port 8: Enabled
Port 9: Enabled, port w/o link
Port 10: Enabled
Port 11: Enabled
Port 12: Enabled
Type <CR> to continue the display... >
If a port range is included, the following is displayed and the ports are
disabled.
ELS10-27> disable 5-6
Port 5: Disabled
Port 6: Disabled
Switch
The switch command,
switch [802.1d | 802.1Q]
[cut[-through] | store[-and-forward]]
[back[pressure] {on | off}]
allows you to select the mode in which the ELS10-27 operates. The two
modes are 802.1D (spanning tree) or 802.1Q (spanning tree with IEEE
VLANs). In addition, you can select cut through or store and forward,