Cabletron Systems SmartSTACK ETHERNET ELS10-27, User Manual

Page: 54 / 126

1-38
Introduction
Trap 3 4 weeks 3 days, 23:41:36 port 15
The current functional state of the port has changed.
Trap 32 4 weeks 3 days, 23:39:36 port 15
The spanning tree state of the port has changed.
Type <CR> to continue, Cntl-C to exit...>
VLAN
The VLAN command, when operating in 802.1Q mode, allows you to
specify an IEEE 802.1Q VLAN. You must specify a VLAN ID, and a name
to associate with that ID. If you want to manage this unit on this VLAN
you must also assign an IP Address.
vlan [add PORT-RANGE NAME VLAN-ID [IP ADDR] [[IP MASK]]
[del[ete] PORT-RANGE {NAME |VLAN-ID}]
[res[trict] {add | de[lete]} PORT-RANGE VLAN-ID]
If the command alone is speciÞed, the existing VLANs are displayed. Two
types of VLANs are displayed; the static entries that have been created by
this command, and dynamic entries which have been learned by the
switch via GVRP.
ELS10-27>vlan
By using the VLAN command, the default VLAN ID for the port WILL
NOT be changed. Refer to the port command to change the default VLAN
ID for a port.
If the restriction option is speciÞed, the switch will not allow a VLAN to
be established for that ID from either a user interface or GVRP.
Workgroup
The workgroup command allows you to group ports together to limit the
scope of broadcast, multicast and unicast packets. If there are no user
deÞned workgroups, one default group exists consisting of all ports. As
workgroups become deÞned, ports are removed from the default group
and added to the newly deÞned group.
VLAN-ID NAME TYPE IP Addr IP MASK PORTS
0x001 default STATIC 10.2.7.225 255.0.0.0 1-27