USER’S GUIDE
706 CyberSWITCH
ser <slot # > signal
displays current state of input signals for each serial line
attached to card in specified slot. “0” indicates inactive;
“1” indicates active.
session
displays the current active administration sessions
session kill <session id>
terminates the active session specified by the session id
snmp stats
displays current SNMP related statistics
sp
lists each semi-permanent device and associated status
start_ne
starts or restarts system software
status (GUEST)
displays system errors and system messages
tcp conns
displays the current TCP connection status
tcp stats
displays the current system TCP statistics
telnet
puts you in the Telnet command mode
see
telnet mode commands
for available commands
telnet <ip-address>[port # ]
begins a Telnet session for the indicated Telnet host
telnet mode commands:
close
exit
open [target host][port # ]
send [send parameter]
set <name><value>
status
toggle
closes the current Telnet connection to a target host
closes the current Telnet session
establishes a Telnet session with a target host
sends special Telnet control functions to the currently
connected target host
sets operating parameters for the current Telnet session
provides information about the current Telnet session
sets operating parameters for the current Telnet session
term
displays the terminal type.
term set <terminal type>
sets the terminal type
tftp get
invokes the TFTP GET command
tftp put
invokes the TFTP PUT command
tftp session
displays TFTP session statistics
tftp session kill <session id>
terminates the active TFTP session specified by the session
id
tftp stats (GUEST)
displays the current TFTP statistics
time [hours:minutes:seconds]
displays or changes current system time
trace [on/off]
enabled or disables call trace information reports
trace ipxwan [on/off]
enables or disables the IPXWAN tracing option
Command
Use