Central Site Remote Access Switch 201
C
ONFIGURING
D
EVICE
L
EVEL
D
ATABASES
On-node Device Entries
IP Routing with IP Host Devices (RFC1294)
To allow an IP Host device to connect to the CyberSWITCH, you must have IP Routing and IP Host
Security enabled. For each IP Host device using this type of connection, you may need to enter the
device’s IP address, IP Host Id, and Calling Line Id.
The following table identifies the configuration requirements for possible security options for IP
Host devices.
IP Routing with PPP IP Devices (Using IPCP)
To allow a PPP IP device to connect to the CyberSWITCH, you must have IP routing enabled. For
each PPP IP Device using this type of connection, you may need to enter the device’s IP address, a
PAP Password or a CHAP Secret, and Calling Line Id.
The following table identifies the configuration requirements for possible security options for PPP
IP Devices.
*Required: An IP address is required if the remote device does not support IP address negotiation.
When the remote device does support IP address negotiation, an IP address is not required.
Note:
If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP
Secret must be entered for both the remote device and for the CyberSWITCH. Refer to
System Information
for information regarding the System Secret. If Outbound
Authentication has been disabled, a CHAP Secret is not required for the remote device.
Security Mode Configuration
On-node Device Table Configuration Data
Calling Line Id
IP Host Id
Calling Line Id
IP Host Id
IP Address
Disabled
Enabled
Not Requested
Required
Required
Enabled
Enabled
Optional per
device entry
Required
Required
Security Mode Configuration
On-node Device Table Configuration Data
Calling Line Id
PAP or CHAP
Security
Calling Line Id
PAP Password
or
CHAP Secret
IP Address
Disabled
Enabled
Not Requested
Required
*Required
Enabled
Enabled
Optional per
device entry
Optional
*Required
Enabled
Disabled
Required
Optional
Optional
