Central Site Remote Access Switch 135
C
ONFIGURING
B
ASIC
IP R
OUTING
IP Network Interfaces
If IP RIP is enabled, enter the following additional information:
h. IP RIP send control
i.
IP RIP respond control
j.
IP RIP receive control
k.
IP RIP v2 authentication control
l.
IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has been
configured with a value other than “No Authentication”
6.
For a WAN IP UnNumbered network interface enter the following information:
a.
MTU size
7.
For a system configured in the IP host operating mode, the following information will be
required for a network interface:
a.
IP address assigned to this interface
b.
subnet mask
c.
MTU size
d. transmit broadcast address
If IP RIP is enabled, enter the following additional information:
e.
IP RIP receive control
f.
IP RIP respond control
g.
IP RIP v2 authentication control
h. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has been
configured with a value other than “No Authentication”
U
SING
M
ANAGE
M
ODE
C
OMMANDS
ipnetif
This command displays the current IP network interface configuration.
N
ETWORK
I
NTERFACE
C
ONFIGURATION
E
LEMENTS
T
YPE
Specifies the interface type: LAN, WAN, WAN Direct Host, WAN RLAN (Remote LAN), or WAN
UnNumbered. For the LAN, you may configure both primary and secondary interfaces. The
primary interface specifies how RIP, IP filters, and proxy ARP operate on all LAN network
interfaces for a specified LAN port.
N
AME
User-defined. An interface name is a 1 to 16 character user-defined string that identifies the
interface to the system administrator. Each interface (LAN or WAN) must have a unique name.
IP A
DDRESS
The IP address (using dotted decimal notation) assigned to this interface. The IP address applies to
LAN type interfaces and WAN type interfaces only. Each LAN interface must be configured with
a unique IP address.
