USER’S GUIDE
556 CyberSWITCH
Out - X25 Call Accept LCN <logical channel number>, <number of bytes> bytes
The DTE is accepting an SVC call.
Out - X25 Call Request LCN <logical channel number>, <number of bytes> bytes
The DTE is attempting to place an SVC call.
Out - X25 Clear Ind LCN <logical channel number>, <number of bytes> bytes
The DCE is clearing the X.25 Virtual circuit on the indicated LCN.
Out - X25 Clear Request LCN <logical channel number>, <number of bytes> bytes
The DTE is clearing the SVC call on the indicated LCN.
Out - X25 CONNECTION REQUEST VcType=<virtual circuit type> ConnId=<connection Id>
Access=<access index> RemDteAddr=<x121 address or protocol/route id>
The system is sending a call request to the network.
Out - X25 CONNECTION RESPONSE ConnId=<connection Id> Access=<access index>
The system is sending a connection to the network. This is sent in response to receiving a call
indication.
Out - X25 DATA LCN <logical channel number>, <number of bytes> bytes
Data transfer.
Out - X25 DISCONNECT REQUEST ConnId=<connection Id> Access=<access index> Cause=<cause for
disconnect>
The system is sending a disconnect to the network to terminate a call.
Out - X25 DISCONNECT RESPONSE ConnId=<connection Id> Access=<access index>
The system has received a disconnect response from the network.
Out - X25 DTE Clear Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that the virtual circuit on the indicated LCN has been cleared.
Out - X25 DTE Interrupt LCN <logical channel number>, <number of bytes> bytes
An interrupt packet has been sent to the DCE. Flow control procedures do not apply to interrupt
packets.
Out - X25 DTE Intr Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming the reception of an interrupt packet from the DCE.
Out - X25 DTE REJ LCN <logical channel number>, <number of bytes> bytes
The DTE has detected a packet sequence error.
Out - X25 DTE Reset Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that the virtual circuit has been reset.
Out - X25 DTE Restart Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that all virtual circuits have been reset.
Out - X25 DTE RNR LCN <logical channel number>, <number of bytes> bytes
The DTE is not ready to receive more data packets.
