Installing Optional Fast Ethernet Interface Modules
6H123-50 and 6H133-37 User’s Guide
C-5
To install a Fast Ethernet Interface Module in port slot 5 or 6 of the
6H123-50, proceed as follows:
1.
Remove the coverplate from the port slot where the Fast Ethernet
Interface Module will be installed.
!
CAUTION
The Fast Ethernet Interface Module and the host module are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could damage the Fast Ethernet Interface Module or the
host module.
!
CAUTION
The FE-100F3 uses Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical
instruments to view laser output increases eye hazard. When
viewing the output optical port, remove power from the network
adapter.
TIP
When installing Fast Ethernet Interface Modules in both slots 5
and 6, remove the coverplates from both slot openings. In the
following instructions, the optional module is shown being
installed in port slot 6.
Summary of Contents for 6H133-37
