Cablescan 90 Series, Setup Manual

Page: 23 / 57

Series 90 Setup Manual Page 13
Series 90L4/H8 Cabinet
Remove front panel from tester. Starting at the left side, install scanner boards consecutively in
the card cage without skipping a slot, as shown in Figure 12. High-voltage scanner boards
cannot be installed in a Series 90L4 and low-voltage scanner boards cannot be installed in a
Series 90H8.
Each model (Series 90L4 or Series 90H8) is contained in one cabinet configuration:
Series 90L4
64 Test Points per connector
(128 Test Points per board.)
Scanner Control First Scanner
Board Board
Series 90H8
32 Test Points per connector
(64 Test Points per board.)
Scanner
First Scanner
Control Board Board
Figure 12. Series 90L4/H8 Scanner Board Locations
NOTE
The Series 90L4 low-voltage scanner boards must have jumpers installed before
they are inserted into the expansion cabinets. For jumper location and settings,
refer to Scanner Board Jumpers, later in this section on page 14.