Cablescan 90 Series, Setup Manual

Page: 19 / 57

Series 90 Setup Manual Page 9
6. Connect VGA monitor to High-density 15-pin D connector (Monitor) on System
Controller.
7. Connect speakerphone jack to Line Out receptacle on System Controller. The Line
Out (Speaker output) phone receptacle is typically green.
8. Connect female end of 9-conductor cable (part number 9100069) to top connector of
Expansion Input/Output Board (Slot 1); connect male end to INPUT connector on
the expansion cabinet.
9. Connect terminating plug (part no. 5211116) to OUTPUT connector on expansion
cabinet.
NOTE
Make sure that all interface cables are secured with their mounting
screws. The most common source of trouble is poor connections.
Adding Expansion Cabinets
1. To add a second expansion cabinet, remove terminating plug from OUTPUT
connector on the first expansion cabinet.
2. Connect the female end of another 9-conductor cable (part number 9100069) to the
OUTPUT connector of first expansion cabinet, and male end to INPUT connector on
second cabinet.
3. If the second cabinet is the last in the chain, connect the terminating plug to its
OUTPUT connector. (The terminating plug is attached only to the last expansion
cabinet.)
OUTPUT
OUTPUT
INPUT
INPUT
LAMP POWER
LAMP POWER
LAMP FUSE
LAMP FUSE
FU
S
E
F
USE F
U
S
E
FU
S
E
F
USE F
U
S
E
1.
2.
Install Terminating Plug
on output connector of
last expansion cabinet
KB
MOUSE
PRINTER
USB
COM1
CO
M
2
MONITOR SPKR
Foot
E
x
pa
ns
io
n
Pro
b
e
Figure 8. Multiple Expansion Cabinet Hookup