- 20 -
cylinder;
[Vibration frequency]: Display the current frequency of the vibration motor when it is working;
Figure 6-7 Signal testing interface
[Round-trip cylinder alignment signal] [Round-trip cylinder top signal] [Round-trip cylinder signal]:
Same as the IO test interface, see Figure 6-5;
[Single vibration frequency]: Set the single vibration frequency for vibration motor debugging;
[Control voltage (V)]: Set the control voltage of the pressurized cylinder for debugging of the
pressurized cylinder;
[Data download]: Click this button to transfer the set parameters to the control card. After changing
the parameters, you must perform this operation to make the parameters take effect;
[Vibration]: This button is used to debug the vibration motor. Click this button, the font of the button
changes to red, the vibration motor runs according to the set [Single Vibration Frequency], and the
[Vibration Frequency] will be displayed on the touch screen; click the button again to stop the
vibration motor.
[Pressurized cylinder]: This button is used to debug the pressurized cylinder. Click this button, the
font of the button will change to red, the pressurized cylinder will press down according to the set
[Control Voltage], [Pressure Sensor Voltage (V)] and [Current Pressure (kN)] will be displayed on the
