- 16 -
[Intermediate position signal]: indicates the intermediate position signal of the round-trip cylinder.
The green indicates that the cylinder is not in the intermediate position, and the red indicates that
the cylinder is in the intermediate position.
[Current pressure (kN)]: Display the real-time loading pressure;
[Loading position]: Click this button to move the round-trip cylinder, and stop when it reaches the
loading position, which is convenient for loading and unloading of test molds;
[Intermediate position]: Click this button, the round-trip cylinder will run to the middle position and
stop;
[Pressure head drop]: Click this button, the pressurize cylinder acts. The indenter will press down
according to the "loading pressure" set during the preloading stage. The content of the button
changes to red "Indenter up"; click the button again, the indenter rises;
[Preloading stage]: Click this button, the device will preload according to the parameters of the pre-
loading stage set in the [Parameter Setting] interface. Compared with the P1~P6 stages, the
vibration motor will not turn on at this stage.
[Reset]: Click this button to restore air source ventilation when the protective door is closed.
[Return]: Click this button to back to the [Test] interface.
Help & Settings interface
In the [Test] interface shown in Figure 6-2, click the "Help & Settings" button, the instrument enters
the [Help & Settings] interface, as shown in Figure 6-4, the description of each button is as follows:
[IO Testing]: Click this button to enter the [IO Testing] interface, as shown in Figure 6-5;
[Signal Testing]: Click this button to enter the [Signal Testing] interface, as shown in Figure 6-7;
[Parameter Setting]: Click this button to enter the [Parameter Setting] interface, as shown in Figure
6-8;
[Pressure Correction Table]: Click this button to enter the [Pressure Correction Table] interface, as
shown in Figure 6-9;
