- 12 -
the instrument will start to run according to the parameters set in P1 Stage. After the P1 Stage is
completed, the instrument will skip to the P2 Stage automatically, the word of “P2 Stage” will turn to
red and the instrument will start to run according to the parameters set in P2 Stage. In this way, the
instrument will automatically stop after the six test stage completed.
If the number of round trips of the P2 Stage is set to 0,
the instrument will automatically skip the P2
stage and proceed to the P3 stage after completing the P1 stage.
If the P2 stage is in progress, click the "P2 stage" button can stop the test.
9. After the test process is completed and the instrument stops, in the [Loading and Unloading
Settings] interface, click the "Loading Position" button, and the mold trolley will move to the left side
of the instrument to facilitate the loading and unloading of the test mold. For specific methods,
please refer to the " Unloading Steps" in the [Help Notes] interface (as shown in Figure 6-11);
10. Turn off the emergency stop switch and disconnect the power supply of the instrument. Open the
protective door on the left, take off the fixed roller of the mold, and remove the rolled mold.
VI.
Software
Startup interface
After the instrument is powered on, the LCD touch screen enters the [Startup] interface (as shown
in Figure 6-1);
