CCD-Premium
Operating manual
page 24 /24
When doing the layout, insert 2 or 3 reference holes with an extra tool number and diameter (use refer -
ence hole function of IsoCam). Use a fresh base sheet and drill these reference holes into it. Press
steel pins or rivets into the holes and use this sheet as base sheet later when processing the boards.
Use the OFFSET command to move the machine's zero position to any place on the table. Fix the raw
cut bare PCB to this location. Drill the reference holes related to the above used tool. Use the reference
holes to position the film artwork. Develop and etch as usual. To drill the board, return to the machine
and fix the board to the reference pins of the prepared base sheet.
If the film artwork does not exactly fit the drill coordinates, use the SCALE edit fields to enlarge or re-
duce the drill image size.
Routing
Also for routing a base sheet is strongly recommended! Fix the plate by span or clamp fixing. Pay at -
tention that it lies straight and even.
If, for example, there is a circle to be routed in FR4 material, the inner part of it will most certainly re -
main where it was on the base sheet. This will of course work only if you use a sharp router and set an
appropriate speed. In IsoCam you can place gaps in the cut out. These “bridges” prevent the cut outs
to be propelled away.
Engraving
The engraving front panels requires a good flatness of the board. Otherwise, the font thickness varies
with the depth of penetration of the V-cut-router. Here is a safe clamp fixation indispensable. For en-
graving you can work with the depth limiter. However, in this case the cooling is less efficient, because
the milling tool is almost completely enclosed. Another trick is to bend the engraving plate a bit, so the
the sides of the plate point upward. Now, when you span down both sides the engraving plate will lie
flat on the base.
Guarantee
Prior to delivery all machines undergo an operational test on function and continuous strength. On the ma-
chine we provide a bring in warranty of 12 months from the date of purchase in respect of defects in material
and workmanship. We offer a warranty at our choice by replacement of faulty parts or by repairing the ma-
chine in our factory. Old parts shall become our property.
Disclaimer of warranty
The warranty does not cover damage due to improper operation, ignorance of this manual and natural wear.
Replacement or subsequent claims of damaged or destroyed work pieces can not be accepted, since we
have no influence on the operation of the machine.
This applies mutatis mutandis to claims for damage to objects, buildings and people and the environment.
All information has been compiled with care. However we cannot guarantee this manual to be error free. We
reserve the right to technical modifications and changes without prior notice.
Operation, in aggressive, dusty, humid, extremely hot or hazardous environment is on the user's own
risk and responsibility.
For appropriate precautions and protective devices, the user has to care himself. Any liability for damage that
is caused by the operation in such environment is hereby expressly excluded.
Copyright
(C) 2014 Bungard Elektronik
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/5036, Fax: +49 (0) 2292/6175, E-mail: [email protected]