CCD-Premium
Operating manual
page 12 /24
Please compare the values in
the machine configuration of
the software to the document-
ation provided with the ma-
chine.
Close the ma-
chine configur-
ation and go to
the tab
Manual
Operation
.
Check
the
function of the
axis by clicking
on the arrow
buttons. When you first click on one arrow, the machine will perform a reference drive. You can
also check the function of spindle as well as camera, dispenser or laser, if there.
ATC:
Check the function of the tool
changer. Go to tab
General
and click
on
Open
to load the project file
ccd_PCB_-29tools-Premiunm This pro-
ject file is located after a normal install-
ation at C:\Program Files (x86)\Route-
Pro3000\Projects.
Go to tab
Run CNC
and click on
the triangle
START
. The next dia-
logue asks you to place the tool
to the corresponding tool slots.
Make sure that the tools have a
length of 38 mm and the distance
between the top of the ring to the
tool tip is 21 mm. Furthermore, a
test tool must be in the spindle
and the tool slot 0 must be empty.
Check the correct fitting of the
tools in the slots. Since there are
tolerances in the ring diameters,
it can be necessary to adjust the
slots. You can easily widen them
with a screwdriver and tighten
them by pressing from outside
against the lamellae.
Press
OK
. The machine now
moves to the tool sensor, checks
the test tool and places it in slot number 0. Then the spindle moves back to the sensor to check
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/5036, Fax: +49 (0) 2292/6175, E-mail: [email protected]
