PANEL PRO
19
To stop, hit the ESC key. Motion stops, but z stays down and the router continues to
run.
If you want to just pause in position, you can switch the SC2 Z and spindle switches to
0. This is good for repositioning clamps. When ready to continue, turn the z and
spindle switches back on and hit enter.
In the case of a broken bit (end mill) the xy axis will have traveled some distance before
you hit ESC. In this case it is better to hit ESC a second time to completely halt
operation. The Z axis will raise and the router turns off. After replacing the bit, you
need to find the entity number to restart the cut.
Click entity list and highlight an entity entry. They are
entered in the order they will cut. Using the mouse or arrow
keys, move through the list until the entity is highlighted that
you want to start on. Click cancel. The Entity listed will be
entered in the cut file start entity.
The file does not need to be simulated again. Click cut the
file.
You will get a warning that the starting position is not zero.
Assuming you have not moved the xy axis hit enter to
acknowledge this is ok. You will get another message
indicating the starting entity is not zero. Hit enter to
acknowledge this also. The skipped entities will be drawn,
but not cut.
DRAWING FOR THE PANEL PRO
