PANEL PRO
15
the drawing library. When the routing starts, the bit must be at the place on the metal
you are cutting that coincides with the drawing reference. For instance, the 0,0 position
of the altimeter.dxf file is in the center of the instrument. Since we want to just cut that
instrument, the 0,0 position of the machine must be at the center of where you want the
instrument cut out. The R key may be used to zero the machine position at its current
location.
AvCAM Machine > find lower left edge is used to set 0,0 to the lower left corner.
Cut a file from metal larger than the finished part:
Select material of adequate size so the router clears the clamps, which are best placed
in the corners. Generally leave about 1 inch around each edge.
Material should be supported about every foot, and spaced away from the rails so you
don’t cut through the rails.
Material spacers are supplied in the tool box. These can be fabricated from
inexpensive plastic lattice strips found in most lumber yards.
Cut a file from an existing blank:
Use a large carpenter square to square the blank with the x axis bearing rail. Take
care that clamps are placed in areas that will not be cut. Clearance must be maintained
from the end mill, and the collet nut.
End mill:
If you are starting a complete panel, it is generally a good idea to install a new end mill.
Used end mills may be used where tolerances or finish are not as critical. End mills
may be inspected using a loupe or strong magnifying glass.
ANY
chipping on the
cutting edge is cause for rejection.
Turn on controller:
The computer and controller may be turned on in any sequence, but normally, turn on
the controller before AvCAM is opened, If AvCAM is started first, then the keyboard R
key must be hit to zero out the xy axis and establish communications.
Verify that the spindle and z axis switches are all on auto (1 position).
Check z axis:
Verify the pressure gage is 40 pounds.
