Bull escalata t430, Setup Manual, Page: 92 / 164

5-10
Setup Guide
SCSI-ID Configuration
•
Media Drive SCSI-ID
, below
•
Hard Disk Drive SCSI-ID
, on page 5-11.
Media Drive SCSI-ID
Each SCSI device must be identified on the SCSI bus by a logical address, called SCSI-ID.
Before installing a media drive, it is necessary to define its SCSI-ID. This is normally done
through switches or jumpers placed at the rear of the device. See the documentation
delivered with the device for the details on setting.
Note: If you purchased the media drive from a supplier other than your system supplier, be
sure that the device itself has no SCSI terminator. Refer to the documentation
delivered with the device.
The SCSI-ID to be set for a given media drive depends on the physical position of this
device.
The following table shows the correspondence between physical position and SCSI-ID for
media drives installed on your system. It also gives the suggested installation sequence.
Notice that there is not a direct link between the installation sequence and the SCSI-ID.
Even if the installation sequence is not the one reported here, you must keep the
correspondence between physical position and SCSI-ID.
MEDIA DRIVE CONFIGURATION TABLE
Device
Area
Physical
Position
SCSI-ID
1 M1 6
M2 5
2 M3 4
M4 3
3 - -
- -
4 - -
- -
5 - -
Legend:
M n = M media drive
n number giving the installation sequence of the devices inside the system unit.