Bull escalata t430, Setup Manual, Page: 134 / 164

6-30
Setup Guide
Hard Disk Drive Removal
Note:
In case you are replacing a faulty hard disk drive, the hot swapping feature enables
you to remove and replace it without stopping the system activity. The procedure is
described in
Device Hot Swapping
, on page 6-33.
1. Before powering off the system, you may need to perform some software operations
(e.g. unmount the file system(s) created on the hard disk). Refer to the operating system
documentation.
2. Perform a system power off and unplug the unit power cord from the wall outlet (for
details, if needed, see Preliminary Operations , on page 6-3).
3. Open the device shutter (for details, if needed, see Device Shutter Opening , on page
6-4).
4. Wear the antistatic wrist strap. It is recommended not to touch the components on the
device back panel (for details, if needed, see How to Handle Hardware Components ,
on page 6-2).
5. Release the disk carrier from the disk cage by opening the latches on the front side.
6. Slide the disk carrier out of the disk cage and lay it on a flat surface.
7. Grip the metal support of the light ducts and pull it out of the disk carrier.
8. Unscrew the screws on the right side of the disk carrier and remove them.