Bull escalata t430, Setup Manual, Page: 120 / 164

6-16
Setup Guide
b. Push the spring, until it is well seated.
6. Lay the controller card on an antistatic envelope and set the jumpers or switches, if any,
according to your configuration requirements. Refer to the documentation delivered with
the controller.
7. Grip the controller card by the edges.
8. Align and slide the controller card into the designated controller card connector on the
system planar.
9. Firmly push the controller card towards the system planar until its finger connector is
plugged in securely.
10.Secure the controller card in the slot by tightening clockwise its retaining screw.
11. Connect any connector cable to the controller card just installed, if any.
Note: If you need to install a SCSI controller to manage internal devices, see SCSI
Controller for Internal Devices , on page 6-18.
Warning: It is recommended to install a slot cover in any free controller card slot.
12.Re-install the left lateral panel (for details, if needed, see
Lateral Panel Installation,
on
page 6-9).
13.Perform a system power on (for details, if needed, see Restart Operations, on page 6-9).
14.You may need to perform some software operations to use the new component (e.g.,
install a new controller driver). Refer to the controller card documentation and to your
operating system documentation. When the required operations are completed, check
that the new card is correctly seen by the system (
lscfg -pv command).