Bull escalata t430, Setup Manual, Page: 71 / 164

Maintaining the System
4-9
Select BOOT OPTIONS to display and/or modify the system boot options. The following
screen is displayed.
System Menu
-
System Configuration
- Manage NVRAM Variables
- Boot Options
Manage NVRAM Variables
Boot options:
auto-boot? true
boot-device cdrom # aixtape disk net
diag-switch? false
diag-device cdrom # aixtape disk net
Cancel OK
The available boot options are:
• auto-boot? , determines the system boot phase:
–
true , an automatic system boot is performed after power on or reset, else
–
false , the Open Firmware menu is called.
•
boot-device
, identifies the device(s) from which the system boots normally
•
diag-switch? , assumes the value of the system key mode switch position:
– false , if the key is set to the Normal position, and the system boots from the device
defined by boot-device , else
– true , if the key is set to the Service position, and the system boots from the device
defined by diag-device .
• diag-device , identifies the device(s) from which the system boots in diagnostic mode for
maintenance purposes.
Select CONFIGURATION VARIABLES to display and/or modify the parameters of the
configuration variables. The following screen is displayed.
System Menu
-
System Configuration
-
Manage NVRAM Variables
- Configuration Variables