41
EN
M1.2.MRD500H.NLFREN - 08022018
MINI TRACKED DUMPER
12
GB
Operation
Never use choke to stop engine.
No oil in the engine originally, but
a bottle of engine oil is in scope
of delivery. Don’t start the engine
before adding oil.
Gasoline is highly flammable and
explosive. You can be burned or
seriously injured when handling fuel.
Use extreme care when handling
gasoline.
Fill the fuel tank outdoors, never
indoors. Gasoline vapors can ignite
if they collect inside an enclosure.
Explosion can result.
DO NOT OVERFILL. Check engine
oil level daily and add as needed.
Engine On/Off Switch
The engine switch has two positions. OFF -
engine will not start or run. ON - engine will
start and run.
Recoil Starter Handle
The Recoil Starter Handle is used to start the
engine.
Fuel Shut-Off Valve
The fuel shut – off has two position.
CLOSED (
) - use this position to service,
transport, or store the unit.
OPEN (
) - use this position to run the unit.
Throttle Control
The throttle control regulates the speed of the
engine, and moves between FAST
, SLOW
, and STOP positions.
The throttle control will shut off the engine
when it is moved to the STOP position.
Choke Control
The choke control is used to choke the
carburetor and assist in starting the engine.
The choke control slides between the CHOKE
CLOSED
and CHOKE OPEN
positions.
Clutch Control Lever
Squeeze the control lever, clutch engaged.
Release the lever, clutch disengaged.
1. Make sure the mini tracked dumper is on a
flat, level surface.
1. The engine must be off and allowed to cool
at least two minutes before adding fuel.
2. Remove the fuel filler cap and fill the tank.
(See engine manual for fuel capacity, fuel
recommendation, and location of fuel cap.)
Add Oil To Engine
Add Oil To Engine
3. Using a funnel, add oil up to the
FULL
mark
on the dipstick. (See engine manual for oil
capacity, oil recommendation, and location
of fill cap.)
2. Remove the oil fill
cap/dipstick to add
oil.
CLOSED
OPEN
09735UK00M110.indd 12
2017/12/20 16:56:23
4 Operation
Add oil to engine
WARNING!
No oil in the engine originally, but a bottle of engine oil is in scope of delivery. Don’t start the
engine before adding oil.
1.
Make sure the tracked dumper is on a flat, level surface.
2.
Remove the oil fill cap/dipstick to add oil.
3. Using a funnel, add oil up to the FULL mark on the dipstick.
WARNING!
Don’t overfill. Check the engine oil level daily
and add as needed.
Add fuel to engine
WARNING!
Gasoline is highly inflammable and explosive. You can be burned or seriously injured when
handling fuel. Use extreme care when adding gasoline.
Fill the fuel tank outdoors, never indoors. Gasoline vapours can ignite if they collect inside an
enclosure. Explosion can result.
1. The engine must be off and allowed to cool at least two minutes before adding fuel.
2.
Remove the fuel filler cap and fill the tank.
WARNING!
Do not overfill!
This equipment and/or its engine may include evaporative emissions control system components,
required to meet EPA and/or CARB regulations, that will only function properly when the fuel tank
has been filled to the recommended level.
Overfilling may cause permanent damage to evaporative emissions control system components.
Filling to the recommended level ensures a vapour gap required to allow for fuel expansion. Pay
close attention while filling the fuel tank to ensure that the recommended fuel level inside the tank
is not exceeded. Use a portable gasoline container with an appropriately sized dispensing spout
when filling the tank. Do not use a funnel or other device that obstructs the view of the tank filling
process.
3. Reinstall the fuel cap and tighten. Always clean up spilled fuel.
Starting engine
1. Move the engine switch to the ON position.
2. Open the fuel shut-off valve.
MINI TRACKED DUMPER
13
GB
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine
may include evaporative emissions
c o n t r o l s y s t e m c o m p o n e n t s ,
required to meet EPA and/or CARB
regulations, that will only function
properly when the fuel tank has been
filled to the recommended level.
Overfilling may cause permanent
damage to evaporative emissions
control system components. Filling
to the recommended level ensures
a vapor gap required to allow for
fuel expansion. Pay close attention
while filling the fuel tank to ensure
that the recommended fuel level
inside the tank is not exceeded. Use
a portable gasoline container with an
appropriately sized dispensing spout
when filling the tank. Do not use a
funnel or other device that obstructs
the view of the tank filling process.
Rapid retraction of the starter cord
(kickback) will pull your handand arm
toward the engine faster than you
can let go. Broken bones, fractures,
bruises, or sprains could result.
3. Reinstall the fuel cap and tighten. Always
clean up spilled fuel.
SLOW
FAST
OPEN
CLOSED
ON
OFF
ON
OFF
SLOW
FAST
OPEN
CLOSED
Starting Engine
1. Move the engine
switch to the ON
position.
2. Open the fuel shut-
off valve.
3. Move the choke
lever to the
CLOSED position.
If the engine is hot,
closing the choke is
not necessary.
4. Move the throttle
lever slightly to the
FAST speed.
5. Pull the recoil starter until the engine starts.
Return the recoil to the home position after
each pull. Repeat the steps as needed. Once
engine has started, set the throttle to the
FAST position before you operate the unit.
Operating
After the engine warms up, move the throttle
lever to accelerate engine speed.
Engage the required gear and slowly squeeze
the clutch control lever. If the gear does not
engage immediately, slowly release the clutch
lever and try again. In this way the mini tracked
dumper will start moving.
The mini tracked dumper has the steering
levers on the handlebars, which makes steering
very easy. To turn right or left, simply pull the
corresponding right or left steering lever.
The sensitivity of the steering increases in
proportion to the speed of the machine and the
load. With an empty machine, a light pressure
on the lever is all that is needed to turn. When
the machine is fully loaded, more pressure is
required.
The mini tracked dumper has a maximum
capacity of 1100 LBS. However, it is advisable
to assess the load and adjust it according to
the ground on which the machine will be used.
It is therefore advisable to cover such stretches
using low gear and taking extra care. In such
situations, the machine should be kept in low
gear for the whole stretch.
09735UK00M110.indd 13
2017/12/20 16:56:29
copyrighted
document
- all
rights
reserved
by
FBC