3.4 - Probe cleaning system (option)
38
TCT-2301 Installation instructions
M2007/3en
©BTG 2004
14. Push the probe and piston into the cylinder. Make sure the guide ring
(10) is in position.
15. Mount the cylinder flanged end (12), the rear cylinder flanged end
(6), and the protective sleeve (3), to the cylinder.
Make sure that the O-rings (7, 8, and 11) are in their proper positions,
and that the nipple (21) on the rear cylinder flanged end are posi-
tioned on the same side of the cylinder as the nipple (20) on the front
cylinder flanged end. The parts must be pulled over the optic cable.
16. Mount the nuts (4) and washers (5), but do not tighten them fully.
17. Connect the air tube (9) to the nipple (21) on the rear cylinder flanged
end.
18. Loosen the screws (24) and turn the protective sleeve until the screw
hole on the guiding rod is visible through the slot (25).
21
20
24
25
22
23
26
