BTG Pulptec SBT-2400, User Manual

Page: 38 / 80

4.4 - HART Communication
32 SBT-2400 Operating Instructions M2041/5en
©BTG 2006
4.4 HART Communication
This transmitter uses the HART universal command specification, revision 5.0 .
The following universal commands are available:
HART Universal
Command
Use in SBT-2400 Comments
0 Read unique identifier Reads device name,
HW and SW revisions,
Tag name and so on -
1 Read primary value Reads consistency -
2 Read primary value
current and percent of
range Reads analog out in
percent of range -
3 Read dynamic
variables and primary
values current Available, not used String empty
4 Reserved Not available -
5 Reserved Not available -
6 Write polling address Write polling addresses -
11 Read unique identifier
associated with tag Same as command 0
but using tag as
identifier. -
12 Read message Read message String empty
13 Read tag, descriptor,
date Read tag, descriptor,
date -
14 Read primary variable
sensor information Available, not used String empty
15 Read primary value
output information -
16 Read final assembly
number Available, not used String empty
17 Write message Available, not used.
See also command 12 String empty
18 Write tag, descriptor,
date See also command 13 -
19 Write finally assembly
number Available, not used.
See also command 16 String empty