Pin Learn
For speed of installation, a single button-press Pin Learn function is
available.
All pins to be used should be wired in and in the non-alarm state.
No tampers should be active if wired in, and Pin 4 (open /close)
should represent the system being set/closed.
When ready, press and hold the down arrow for three seconds. ‘Notice
– Done!’ is displayed when finished.
This has completed the Pin Learn. There’s also an option to Pin Learn
within the configuration menu.
Configuration menu programming
The unit comes pre-configured with factory default values. For most
installations, you won’t need to make changes to the configuration.
You can configure the unit using either the on-board configuration
menu driven by the buttons, through the installer app or web portal,
connecting a laptop to the Ethernet port or using the Essential IP
access point.
A minority of sites may need minimal configuration changes at
installation, and most of these will be achievable through the button
configuration – for example:
• Change the individual pin status.
• Connect to wi-fi using WPS
• Enable Dual End of Line for interconnection monitoring.
• Change the IP mode from Ethernet to wi-fi.
• Change from dynamic to static IP addressing, and allocate a static
IP address/subnet/gateway address.
Notice –
Done!
Configuration
Press & Hold for Pin Learn
12