Commissioning
B 3
ekrPro Com
60
web guide controller
EDV No.:
MD.191.01.05/1.6.x Chapter:
B 3
with analog sensors
Date:
23.11.2007
Page:
32/73
Pos. Limit –
Setting the actuator path limits (software limit switches)
This sub-directory is only be used if an actuator with position
feedback (for example, EMS 17) is connected to the system.
This enables you to limit the actuator paths.
1. Select
Actuator
in
General Setup
, then the sub-directory
SC-Transducer
and finally
Pos. Limit
.
Confirm the respective selection by pressing ENTER.
2. Use the vertical arrow keys to deactivate the checkbox
active
.
This deactivates the function of both limit switches.
The settings can
only be entered in the deactivated state.
3. Use the
F2
key to drive the actuator until it reaches the
required left limit switch position.
The actual position of the actuator supplied by the position
feedback is shown in the middle above the F2 and F3 keys.
4. Confirm this position by pressing the
F1
key.
The limit switch position is stored.
The corresponding position value is shown below the
checkbox.
5. Use the
F3
key to traverse the actuator until it reaches the
required right limit switch position.
6. Confirm this position by pressing the
F4
key.
7. Reactivate both limit switches.
Select (x) checkbox
active
to do this.
The description is given in section 2.
Import of the limit switch position is indicated by a black circle
in the read-only checkbox above the
F1
and/or
F4
key.
8. Press the
ESC
button to exit the inputting menu.
