48
GS-X Pinsetter w/Advanced (CE) Guarding Operation Manual
Error Codes Description and Causes
STD.
CODE
EXTENDED
CODE *
FAILURE DESCRIPTION
POSSIBLE CAUSES
PO
Pin OOR
TABLE CAN'T PICK UP PINS,
OUT-OF-RANGE - The Table was
unable to lower to it's normal detecting
height.
1.
2.
3.
4.
A bowling pin has been moved off its normal spot when the bowler rolled the ball.
The table came down and it was resting on top of the pin. Turn off the power, clear
any fallen pins still on the playing surface of the lane, and turn power back on.
The OOR switch mounted on the tower is not being actuated. Check the switch and
actuating cam for proper adjustment. Check the wiring and connections between
the switch and P-1/P-23 on the Nexgen Controller.
Switch cluster timing cam out of adjustment.
Table is not lowering properly. Check for binds in the table racks or the chain
lowering mechanism.
01
02
03
04
05
06
07
08
09
10
Pin1 Ld
Pin2 Ld
Pin3 Ld
Pin4 Ld
Pin5 Ld
Pin6 Ld
Pin7 Ld
Pin8 Ld
Pin9 Ld
Pin10 Ld
PIN LOADING TIME OUT
A pin was not loaded into the pinholder
within 90 seconds.
1.
2.
3.
4.
5.
6.
7.
Pins jammed in one of the distributor lanes preventing the pin station form receiving
a pin.
Pin holder switch not working properly. Check for broken switch or wiring.
Pin Holder solenoid not energizing. Check the solenoid, the wiring and the Nexgen
Controller.
Table height too high, preventing the pin from dropping properly into the pin holder
to make the switch.
Table height too low preventing the pin holder's open gripper from pushing up on the
pin release lever to drop the pin. Also check individual pin release lever for proper
positioning.
Pin count switch not functioning properly.
For Nexgen Electronics, swap the CPU PCB. Also, swap the interconnecting cables
to help isolate the problem.
