BRP SPARK SERIES, Operator'S Manual

Page: 95 / 148

MAINTENANCE PROCEDURES
WARNING
The tether cord must always be
removed from the engine cut-off
switch prior to inspecting the in-
take grate.
NOTE: There is a reinforcement plate
on LH side of hull to maintain symme-
try so the hydrodynamics of PWC is not
affected.
smo2014-005-045_a
1. Water intake
2. Heat exchanger
3. Reinforcement plate
Sacrificial Anode
Sacrificial Anode Inspection
Check for wear. If worn more than half,
replace anode.
smr2014-039-001_a
1. Sacrificial anode location
Sacrificial Anode Removal
Unscrew sacrificial anode retaining nut
and remove anode.
Sacrificial Anode Installation
Installation is the reverse of the re-
moval procedure.
Torque anode retaining nut as specified
in exploded view.
Fuses
Fuse Removal and Installation
Use the fuse remover/installer in-
cluded in the fuse box to ease fuse
removal.
Fuse Inspection
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
A 1 5 E 0KZ
1
2
3
1. Fuse
2. Check if melted
3. Ampere rating
WARNING
Do not use a higher rated fuse
as this can cause severe dam-
age. If a fuse has burnt out, the
source of the malfunction should
be determined and corrected be-
fore restarting. See an authorized
Sea-Doo dealer for servicing.
_______________
93