BRP SPARK SERIES, Operator'S Manual

Page: 39 / 148

PRE-RIDE INSPECTION
Hull
Inspect hull for cracks and other dam-
ages.
Jet Pump Water Intake
Remove weeds, shells, debris or any-
thing else that could restrict the flow of
water and damage the propulsion unit.
Clean as necessary. If any obstruction
cannot be removed, refer to an autho-
rized Sea-Doo dealer for servicing.
NOTE: There is a reinforcement plate
on LH side of hull to maintain symme-
try so the hydrodynamics of PWC are
not affected.
smo2014-005-045_a
TYPICAL
1. Water intake
2. Heat exchanger
3. Reinforcement plate
Drain Plug
Secure bilge drain plug.
smo2014-005-005_a
TYPICAL
1. Bilge drain plug
Step 1: Untighten
Step 2: Tighten
WARNING
Ensure bilge drain plug is properly
secured prior to launching the wa-
tercraft in water.
Fuel Tank
Fill the fuel tank.
WARNING
Strictly adhere to instructions de-
tailed in
FUELING PROCEDURE
.
Engine Compartment
Inspect the engine compartment for
fuel vapor odor.
WARNING
Should any leak or gasoline odor
be present, do not apply electri-
cal power or start the engine.You
should seek service from an autho-
rized Sea-Doo dealer, repair shop,
or person of your own choosing
for maintenance, repair, or re-
placement. Please refer to the
US
EPA EMISSIONS-RELATED WAR-
RANTY
contained herein for infor-
mation about warranty claims.
________
SAFETY INFORMATION
________
37