BRP SPARK SERIES, Operator'S Manual

Page: 81 / 148

MAINTENANCE SCHEDULE
FIR S T 50 HOUR S OR 1 YEAR
EVERY 100 HOUR S OR 1 YEAR
EVERY 200 HOUR S OR 2 YEAR S
A: ADJU S T
C : C LEAN
I: IN S PE C T
L: LUBRI C ATE
R: REPLA C E
O: OPERATOR
R
S : REPAIR S HOP
TO BE PERFORMED BY
PART/TA S K NOTE
iBR S Y S TEM (intelligent B r ake and Reve r se)
iBR lever (6) I, L O/RS
iBR gate backlash I I RS
iBR support plates I I RS
iBR friction sleeves I I RS
iBR connecting arm, sleeve and screws I I RS
iBR nut I I RS
iBR boot I I RS
iBR gate bushings I I RS
iBR air chamber I (11) RS
iBR protective guard I I RS
(6) See NOTE 2 at the end of
maintenance schedule table.
(11) Verify if there is water
inside the air chamber. If
water is present, it means
that the iBR nut has a leak and
needs to be replaced.
HULL AND BODY
Hull I O
Ride plate, heat exchanger, water intake
grate and reinforcement plate
I O
—
NOTE 1: Inspect for possible leak or damage on oil seal or two water seals, and PTO sleeve surface.
Lubricate grease chamber between the two water seals.
NOTE 2: The iTC and iBR levers should be inspected by depressing and releasing the levers to check for
freedom of movement. If any friction is felt, the lever must be taken apart, cleaned, inspected for
wear and lubricated, refer to an authorized Sea-Doo dealer.
_______________
79