BRP E250DHLSCS, Service Manual

Page: 345 / 396

343
TRIM AND TILT
ADJUSTMENTS
14
Fill the reservoir to the bottom of the fill hole with
Power Trim/Tilt & Steering Fluid
. Install and
tighten the reservoir cap. Turn the manual release
valve in until it seats. Cycle the unit up and down
several times to purge air.
Operate the unit to the full UP position, then run
down momentarily to release pressure. Check the
fluid level again and add fluid, if necessary.
Remember that all rods must be completely up to
check the fluid level. Test the unit by performing
the
Pressure Leakdown Test
on p. 323.
Check the tilt rod bushings. Replace them if they
are worn excessively.
Check the bushings on the bottom of the manifold
body. Replace them if they are worn excessively.
Check system operation in both trim and tilt range.
ADJUSTMENTS
Refer to
Trim Sending Unit Adjustment
on
p. 67.
Refer to
Tilt Limit Switch Adjustment
on p. 66.
41859
41885
41888
41878