BRP E250DHLSCS, Service Manual

Page: 292 / 396

290
GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Inspect the bearing housing anode. Replace
anode if it is reduced to two-thirds of original size.
Tighten screws to a torque of 108 to 132 in. lbs.
(12 to 15 N·m).
Discard the bearing housing O-rings. Clean the
housing and bearings in solvent and dry thor-
oughly. If bearings were not replaced, rotate the
needles to check for freedom of movement.
Inspect O-ring grooves. Sand off any sharp edges
that might cut O-ring. Remove any nicks or burrs
on front of bearing housing.
Bearing Installation
Oil, then install new bearings in bearing housing.
Place the
lettered end
of the bearing case on the
bearing installer, then press the bearing into the
housing until the tool seats. When installed, the
lettered end of the bearing should be visible.
S
TANDARD
R
OTATION
H
OUSING
Bearing Installation Tool:
•
P/N 354139 – front and rear bearings
1. Anode
006897
1. O-ring groove
006898
1
1
Front Bearing
1. Bearing installation tool
006909
Rear Bearing
1. Bearing installation tool
006910
1
1