BRP E250DHLSCS, Service Manual

Page: 237 / 396

235
POWERHEAD
POWERHEAD ASSEMBLY
11
Apply
Permatex No. 2
to crankcase flange screws
where threaded hole is open to crankcase.Install
screws and tighten to to a torque of 84 to 108 in.
lbs. (9.5 to 12 N·m).
Test that the crankshaft spins freely without bind-
ing.
Apply
Nut Lock
to the upper and lower crankcase
head screws. Install and tighten screws to a
torque of 96 to 120 in. lbs. (11 to 13.5 N·m).
IMPORTANT:
After powerhead has been
assembled, allow at least two hours for
Gel-Seal II
to cure before running outboard.
Shift Linkage Installation
Lubricate shift linkage bosses at the base of the
crankcase with
Triple-Guard
grease. Insert bush-
ings into bosses.
Apply
Triple-Guard
grease to the shaft of the shift
lever assembly. Guide shaft through bushings in
crankcase.
Install shift rod lever and tighten retaining screw
60 to 84 in. lbs. (7 to 9.5 N·m).
Apply
Triple-Guard
grease to shoulder of shift arm
screw and
Nut Lock
to threads. Install arm, screw,
and washer and tighten screw to a torque of 120
to 144 in. lbs. (13.5 to 16.5 N·m).
004138
004142
1. Shoulder screw
2. Shift rod lever retaining screw
004145
2
1