BRP E250DHLSCS, Service Manual

Page: 202 / 396

200
OILING SYSTEM
OIL COMPONENT SERVICING
Install oil pump on bracket with clamp and retain-
ing screw. Tighten to a torque of 24 to 36 in. lbs.
(3 to 4 N·m).
Reconnect the electrical connector.
IMPORTANT:
Use oil primer bulb to purge air
from oil supply hose before reconnecting hose to
oil pump.
Reconnect oil supply hose to the inlet fitting of oil
pump. Fasten with
Oetiker
clamp.
Make sure oiling system is primed. Check oil flow
through oil distribution hoses. Check oil system
operation and routing of oil hoses. Refer to
Oil
Supply Priming
on p. 59.
Run the outboard and check for leaks.
Repair any oil leaks and any kinked or misrouted
hoses.
1. Clamp
004220
1
1. Oil supply hose
2. Oetiker clamp
005519
2
1