B.U.D.S. PROGRAMMING
Wheel Beadlock
Wheel Beadlock Tightening
XT-P Model
NOTICE
Do not use an impact wrench for
tightening beadlock screws in order to avoid
to damage them.
Check beadlock screws tightening as per the fol-
lowing sequence.
tbl2011-001-068_a
PART
TORQUE
Beadlock screws
8 N•m (71 lbf•
in
)
Wheel Beadlock Gap Verification
XT-P Model
Verify the gap between tire and beadlock clamp
ring, it should be practically equal all around the
ring.
vbs2010-007-007_a
A. Gap equal all around bead lock clamp ring
Readjust if required. Refer to proper shop manual
for complete procedure.
Protective Materials
Ensure that all protective materials are removed
from vehicle.
Recall or Factory-directed
Modification
Complete applicable recall or factory-directed
modification.
B.U.D.S. PROGRAMMING
Diagnostic Connector Location
The diagnostic connector is located under the
dashboard on the driver's side. It is stored in its
protective cap on the lower RH side of the battery
rack.
tmr2011-019-001_a
1. Diagnostic connector
NOTE:
Do not mismatch the diagnostic connector
with the one on the LH side of the battery rack.
This connector has 2 wires and is for manufac-
turer use only.
Connecting the PC to the
Vehicle
REQUIRED TOOLS
MPI-2 DIAGNOSTIC CABLE
(P/N 710 000 851)
MPI-2 INTERFACE CARD
(P/N 529 036 018)
1. Locate the 6-pin diagnostic connector, refer to
DIAGNOSTIC CONNECTOR LOCATION
.
2. Disconnect the 6-pin diagnostic connector from
its holder (protective cap).
PREDELIVERY
2014-2
37 / 54