PARTS TO BE INSTALLED
tsi2011-001-002_a
1. Neoprene seal
4. Install foam gasket into on all rounded sec-
tions, previously cleaned with isopropyl alcohol,
where roof middle section will be in contact
with cage tubes.
5. Install straps holder on roof middle section as
depicted on picture below.
tsi2011-001-006_a
1. Strap toward outside for rear section
2. Strap toward inside for front section
NOTE:
Slots in strap holders are for roof adjust-
ment against cage tubes and sport visor.
6. Secure strap holders in place with k50 screws
from the roof middle section installation kit.
Tighten screws to specification.
TORQUE
Strap holder screws
2.5 N•m (22 lbf•
in
)
7. Install roof middle section above sport visor.
Pay attention to fit both tops with notch be-
tween both.
8. Install straps around cage tube. Do not tighten
before all straps are installed.
9. Tighten each strap.
Rear Speakers (LTD Models)
REQUIRED PARTS
QTY
Rear speaker
(from predelivery box #1)
2
Rear speaker installation kit
(from predelivery box #1)
1
Speakers are identified by a letter to the back of
box, in the rounded section.
SPEAKER LETTER
POSITION
L
Left side
R
Right side
1. Install foam gasket on rounded section, pre-
viously cleaned with isopropyl alcohol, where
rear speaker box will be in contact with cage
tube.
tbl2012-003-020_a
1. Foam gasket
2. Slacken strap holder screw and position the
rear speaker box on cage. Move the strap
holder to determine the best position.
tbl2012-003-021_a
1. Strap holder
2. Strap holder screws
PREDELIVERY
2014-2
27 / 54
