4. X AND Y PARALLEL MOVEMENT OF SEWING PATTERNS
BAS-311H
35
4. X AND Y PARALLEL MOVEMENT OF SEWING
PATTERNS
The work clamp can be moved to any desire position so that sewing patterns can be moved in parallel directions forward,
back, or to the left or right.
Use this when you would like to correct the sewing position with respect to the intermittent work clamp.
1
2776B
Press the
△
or
▽
key to select the program number.
*
If a cycle program has been selected, the following
operation cannot be carried out. Select a program from
1 to 999.
2
While holding down the TEST key, press the
▽
key to
switch to parallel movement mode.
･
The amount of parallel movement in the horizontal
direction which has currently been set will be displayed
in the menu display in mm units.
3204B 2648B
3
4441Q
Depress the foot switch to the 2nd step.
･
Home position detection will be carried out.
･
The pattern number will change to illuminated.
4
3205B
Each time the
▲
or
▼
key is pressed, the work clamp will
move by 0.05 mm.
･
In X-scale parallel movement mode, the work clamp
will move to the left when the
▲
key is pressed, and to
the right when the
▼
key is pressed.
･
The movement units change in accordance with the
movement distance.
0 - 9.95 mm : Increments of 0.05 mm
10.0 - 99.9 mm : Increments of 0.1 mm
100 - : Increments of 1 mm
5
Confirm the movement amount
2414B
Press the ENTER key.
･
The amount of parallel movement in the horizontal
direction will be confirmed, and the menu display will
change to illuminated.
For example, program
No.1
2nd step
(Continued on next page)
For example, set to 0.05.
