90
Programmer
Chapter 2 Programming with Help Function
Creating a zigzag circle
The following five options are available for creating a zigzag circle.
Creating a zigzag circle by specifying 3 points on the circumference
Creating a zigzag circle of the specified diameter in the clockwise direction
Creating a zigzag circle of the specified diameter in the counterclockwise direction
Creating a zigzag circle of the specified radius in the clockwise direction
Creating a zigzag circle of the specified radius in the counterclockwise direction
1.
Select
and press
. (The position where
was pushed becomes the 1st point of the
zigzag circle.)
2.
Select an option of creating a zigzag circle, then press
.
If
is selected
1.
Input the zigzag stitch width, stitch length and the overlap stitch count, then press
.
Values of 0 - 9 are available for input.
2.
Move the needle with
to select the second point and press
.
Press
for selection.
Zigzag pitch
Stitch count for overlap sewing
Zigzag width
Remaining plot count
Distance from the previous point
in the direction of X or Y axis
Summary of Contents for BAS-300F Series
