Broadcom NetXtreme BCM57 Series, User Manual

Page: 136 / 174

Broadcom Gigabit Ethernet Teaming Services NetXtreme User Guide
Broadcom
®
April 2017 • 2CS57XX-CDUM514-R Page 136
7 Network controller configured for
10Mb full-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.
8 Network controller configured for
100Mb half-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.
9 Network controller configured for
100Mb full-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.
10 Network controller configured for
1Gb half-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.
11 Network controller configured for
1Gb full-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.
12 Medium not supported. The operating system does
not support the IEEE 802.3
medium.
Reboot the operating
system, run a virus check,
run a disk check (chkdsk),
and reinstall the operating
system.
13 Unable to register the interrupt
service routine.
The device driver cannot
install the interrupt handler.
Reboot the operating
system; remove other
device drivers that may be
sharing the same IRQ.
14 Unable to map IO space. The device driver cannot
allocate memory-mapped
I/O to access driver
registers.
Remove other adapters
from the system, reduce the
amount of physical memory
installed, and replace the
adapter.
15 Driver initialized successfully. The driver has successfully
loaded.
Informational message only.
No action is required.
16 NDIS is resetting the miniport
driver.
The NDIS layer has
detected a problem
sending/receiving packets
and is resetting the driver
to resolve the problem.
Run Broadcom Advanced
Control Suite diagnostics;
check that the network
cable is good.
18 Unknown PHY detected. Using a
default PHY initialization routine.
The driver could not read
the PHY ID.
Replace the adapter.
19 This driver does not support this
device. Upgrade to the latest
driver.
The driver does not
recognize the installed
adapter.
Upgrade to a driver version
that supports this adapter.
Table 15: Base Driver Event Log Messages (Cont.)
Message
Number
Message Cause Corrective Action