British Leyland Triumph Toledo, Repair Manual

Page: 131 / 339

SYNCHROMESH GEARBOX
GEAR-CHANGE LEVER
—Check and adjust 37.16.01
1. Drive the vehicle onto a ramp and raise the ramp.
2. Slacken the locknut.
3. Place the gear lever in the neutral position of the
lst/2nd gate.
4. Adjust the stop bolt to prevent inadavertent selec­
tion of the reverse gate without depressing the lever.
Check that the reverse gate can be selected by
depressing the lever.
NOTE: Failure to obtain the required adjustment
will necessitate the renewal of the reverse stop bolt
and reverse stop plate.
5. Tighten the locknut.
O
GEAR-CHANGE LEVER
—Remove and refit 37.16.04
1. Drive the vehicle onto a ramp.
2. Remove the gear lever grommet. 37.16.05.
Removing
3. Remove the fabric washer (if fitted).
4. Raise the ramp.
5. Working from below the vehicle, unscrew the nut.
6. Remove the bolt and washer.
7. Lower the ramp.
8. Working from the passenger compartment, release
the cap.
9. Remove the steel and nylon cups.
10. Remove the spring.
11. Withdraw the gear-change lever.
Refitting
12. Fit the gear-change lever into the extension.
13. Replace the spring.
14. Replace the nylon and steel cups.
15. Refit the cap.
16. Raise the ramp.
17. Working from below the vehicle, assemble the lever
to the selector shaft and fit the bolt and washer.
18. Fit and tighten the nut to a torque loading of 0-8 to
1-1 kgf m (6 to 8 lbf ft).
19. Adjust the reverse stop bolt. 37.16.01.
20. Lower the ramp.
21. Working from the passenger compartment, refit the
fabric washer.
22. Refit the gear lever grommet. 37.16.05.
g7.16.01
37.16.04
.#