Instructions for Installation & Use
- Series No. 8100/A/2010
Instructions for Installation & Use
- Series No. 8100/A/2010
20
21
HOW TO INSTALL
HOW TO INSTALL
D.
Engage car seat belt buckle
and tongue. Push down on
the restraint while pulling on
the lap portion to remove all
slack from the belt. Then,
pull the remaining slack
in the sash belt and allow
excess belt to feed back into
the retractor.
Engage
seatbelt
Remove all
slack from
lap portion,
then sash.
Feed through
seatbelt path.
Car's Seatbelt
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
E.
To lengthen the Upper Anchorage Strap, fully
press Adjuster Button (A) while pulling Upper
Anchorage Strap (B) to slacken as shown right.
F.
Connect the Attachment Clip to the
Anchor Fitting in the car making
sure to remove as many twists as
possible.
G.
Pull Upper Anchorage Adjustment Strap (C)
to remove any slack but do not tighten so
much that the restraint lifts off the car seat.
Fold up excess strap and use Storage band
to firmly store excess strap behind seat.
Always attach hook and remove slack.
E
Attachment Clip
Car's Anchor
Fitting
Always ensure that the car seat belt and upper anchorage strap are firmly restraining the restraint
on the vehicle seat.
Make sure Cup Holders (If fitted) do not interfere with closure of the car door.
IMPORTANT :
Storage
Band
B
A
Roll up excess
strap and store with
the storage band.
Fully press Adjuster Button (A) while pulling
Upper Anchorage Strap (B) to lengthen.
Pull Adjustment Strap
to remove slack
Storage
Band
C
A
