Instructions for Installation & Use
- Series No. 8100/A/2010
Instructions for Installation & Use
- Series No. 8100/A/2010
28
29
HOW TO SET-UP
CONVERTING THE TODDLER RESTRAINT INTO BOOSTER SEAT
To use this child restraint as a booster seat the harness needs to be stored under the cover.
Disengage and remove the seat belt from the restraint.
You will need to remove the upper anchorage strap from the anchor fitting when converting to a
booster seat.
Upper anchorage strap must always be used in this booster position when re installed.
If fitted, remove all comfort accessories from the restraint.
STORING ACCESSORIES IN SEAT RECESS
When used as a Booster seat, the SLIDEGUARD™ converter is found in storage recesses under the
cover, as shown below and is connected to the buckle to form the SLIDEGUARD™Converter.
Toddler Use
Child Use with
SLIDEGUARD™ Converter
SLIDEGUARD™ converter
Place Harness strap and Harness
Tongue behind trim in recess
CHILD USE
(BOOSTER SE
AT
MODE)
CHILD USE
(BOOSTER SE
AT
MODE)
HOW TO SET-UP
STORING THE IN-BUILT HARNESS
A.
Disengage harness buckle. Fully lengthen the
harness by pressing the Harness Adjustment lever
and pulling the harness shoulder straps.
B.
Place shoulder straps behind trim and slide the
tongues down into the storage inserts in the seat
base.
C.
Remove the elastic loops holding the cover in place
at the lower front of the seat. Lift the cover to expose
the storage inserts in the seat base.
A
B
C
NOTE:
Do not disconnect the harness at the
back of the restraint when storing the harness.
