Instructions for Installation & Use
- Series No. 8100/A/2010
Instructions for Installation & Use
- Series No. 8100/A/2010
18
19
HOW TO INSTALL
HOW TO INSTALL
INSTALLING INTO VEHICLE
(FORWARD FACING) (UPRIGHT OR RECLINED)
A.
Determine whether an upright or reclined installation
is preferred as shown right.
B.
To move the Recline Foot from upright to reclined
mode or vice versa. Pull the Foot outwards to unlock
it, then rotate the foot. Push to lock in place. See
diagrams below.
Reclined
Upright
Pull out
Rotate
Push in
to lock
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
C.
Position restraint centrally to the chosen position in forward facing mode and align restraint centrally
to the chosen seating position. Some vehicle seat fabrics (particularly velours) may be damaged by
a child restraint used continuously. We recommend the use of the Safe-n-Sound™ Messy Mat or
other protection to keep the vehicle seat in good condition.
Pull the centre panel flap down and gently lift headrest
trim end.
Fully lengthen seat belt and feed the seat belt through
the closest seatbelt path slot and pass across the
seating surface through the opposite slot. Follow the
yellow belt path label -
FORWARD-FACING BELT PATH
Engage
into Seat
belt buckle
Seat belt feeds
through slot in
seat between
trim and seat
back.
Yellow Belt Path label
FORWARD-FACING
BELT PATH
Near seat
belt slot
Far seat
belt slot
If the car seat belt does not remain firm in everyday
use, then contact the retailer, or Safe-n-Sound customer
service for a gated 3-bar slide (order No. 0215).
Rolled up
towel or
padding
NOTE:
Some car seats have more rearward slope than others.
Use a rolled up towel or padding under the seat for contoured
vehicle seats to prevent excessive recline.
Headrest trim end
Centre
panel flap
Feed through
seatbelt path.
Car's Seatbelt
